Although the cylinder is placed horizontally, the material is pushed forward, Slowly flow out from the feeding end to the discharging end, and finally complete the grinding operation.

The transmission methods of mills are divided into three types: central transmission, edge transmission, and gearless transmission.

3.7 The insulation material of the hollow shaft is defective and needs to be rectified during major repairs.

3、 Common faults and troubleshooting of cement mill: 1.

3.3 Check if the valves of the lubrication system are in place.

3.1 Check the lubricating oil level to ensure that there is sufficient lubricating oil.

The crushing capacity of the mill is insufficient, and a slightly larger ball is added.

The function of the main bearing is to support the entire rotating part of the mill; 5.

While the material is subjected to impact and grinding, the material inside the grinding body is continuously forced to feed due to the movement of the rotating part of the cylinder.

3.2 Check whether the lubricating oil pump works normally and remove any fault in time.

3.6 If the temperature of the discharged cement is too high, adjust the temperature of the discharged cement.

The function of grinding the inner lining plate is not only to protect the cylinder from wear and tear from the grinding body and materials.

There is too much slag in the grinding tailings.

3.8 Inspection and treatment of hollow bearing surface
.

Bend Loop

2.

The phenomenon of full grinding in the second chamber of the mill and its treatment.

2、 The working principle of the grinding machine is that when the grinding machine is in operation, the grinding body falls back together with the cylinder under the action of inertia and centrifugal force, and is carried to a certain height.

2.4 Pulse feeding, uniform and stable feeding.

3.5 Check the cooling water volume and temperature, ensure sufficient cooling water, and control the cooling water temperature not to be too high.

The basic structure of grinding machines mainly consists of five parts: feeding device, supporting device, rotating device, unloading device, and transmission device; 2.

Due to the fact that the working surface state of the lining plate can change the motion state of the grinding body, it can also be used to improve the grinding effect; 4.

1、 Basic structure knowledge of grinding machines: 1.

2.

3.4 Check if the oil filter is blocked and clean it in a timely manner.

At this height and under a certain speed and gravity, it falls like a projectile, crushing the material.

2.

The arrangement of the castor holes in the partition board mainly consists of concentric circles and radial shapes.

The gear transmission methods of mills include edge transmission and central transmission; 3.

The phenomenon of full grinding in the first chamber of the mill and its treatment methods.

3.

2.3 Full grinding, see the treatment method for full grinding.

Furthermore, the height difference of the material surface between the feeding end and the discharging end is borrowed.

The temperature of the mill bearing pad is too high.

There are two lubrication methods for the main bearing of the mill, namely oil injection into the oil pump and oil ring lubrication.

In addition, the grinding body also produces sliding and rolling, causing crushing and grinding between the grinding body, lining plate, and material, resulting in fine grinding of the material.

2.2 The material flow rate inside the mill is too fast, reducing ventilation inside the mill.